The mark consists of The schema for all BRE race cars is as follows: Car has diagonal stripes that extend from the top rear of the front quarter panel, across the door seam, to the bottom of the front of the door. Approximately 1/3 down the length of the stripes there is a break where the name Datsun or BRE is placed. Car is to be painted in at least two contrasting colors. The first color is to extend from the front of the car (front spoiler) over the top of the car (hood, roof and trunk lid) down the back of the car (down the backside and below the bumper). This "top" color is to extend slightly down the sides of the car (approx 2 inches). This "top" color is to be used for the stripes. In the case of a two-color car the "top" color will be the color of the entire stripes. The second color is to be used: (1) For the sides of the car, filling in the entire area from below the line of the top color to the bottom of the car. (2) On the back of the car in the area that houses the brake lights. (3) As a "panel insert" on the back half of the top of the car. There is the option to use a third color. If a third color is used it will be used as the color of the bottom 2/3rds of the diagonal stripes. The BRE logo is to be visible from all sides of the car. In the back it will be placed where a license plate would reside. In the front it will be on the spoiler. On the sides it is to be placed where side marker lights would normally be located.